Thanks. AudioVOX September 14, 2018, 4:58pm #3. Please verify that the charging contacts are clean before you insert the battery. Do you hear a sound when the battery is inserted in the robot. This sound indicates that the battery is well connected.
What is Irobot charging error 3?
Blinks Three Times, Displays “Err3”, or Says “Charging Error 3” You need to reset the Roomba’s software. To do this, hold the two buttons above and below CLEAN simultaneously for 10 seconds. Then try charging your Roomba again.
How do I fix my Roomba not charging?
If your Roomba is not charging, clean the charging ports with a soft cloth and some rubbing alcohol to remove dust, hair, or gunk accumulation. You may also have to reinstall or replace your battery or charging dock or even reset the Roomba to factory settings.
How do I reset my Roomba battery?
How to reset the Roomba battery?
- Press the CLEAN button to turn on the Roomba.
- Hit the SPOT and DOCK buttons simultaneously for 10 seconds.
- Release both buttons at the same time as soon as you hear the typical beep sound.
- Stop loading the robot for at least 12 hours and then try it.
Why does my Roomba keep saying charging error?
Charging Error 5 means your robot’s charging system isn’t working correctly. … If found, use a clean dry cloth to remove debris from the charging contacts. 4. Reinstall the battery and replace the bottom cover and battery door, and then place Roomba back on the Home Base® to try charging again.
How do I know if my Roomba battery is bad?
The power light on a fully charged Roomba will come on in a green solid color. On the other hand, when the battery is charging you will notice a pulsing amber color. Additionally, the light will be flashing red when the battery is too low and solid red when completely drained.
How do I check my Roomba battery?
Charge Roomba using the Home Base. Indicator lights will turn off after 60 seconds to conserve energy while Roomba is charging. Check status of the battery by pressing the CLEAN button to illuminate the Battery Indicator. Indicator will appear amber while the battery is charging and solid green when fully charged.
Wi-Fi Connected 600 & 800 Series Robots: Press and Hold the Dock and Spot Clean and CLEAN button down until the robot makes a beep tone, then release. Roomba Combo: Open the lid and locate the recessed Reset button to the left of the On/Off switch. Press and hold the Reset button for ten seconds.
The flashing orange light means it senses that the battery has been discharged and when docked it is recharging. Do not interrupt the cycle of charging the orange blinking light will cease and the unit should operate normally once charging is complete.