Why is my Roomba not returning to home base?

Why does my Roomba not go home when I tell it to?

Infrared interference

Virtual walls, lighthouses, and other home bases can cause interference and restrict your Roomba from getting back to its base. Ensure that every form of potential interference is at least 2.4 meters away from the home base.

How do you get Roomba to go back to home base?

Download Article. Press the dock button on your Roomba. Look for the “Home” button along the top of your device—this is a small, circular button to the left of the larger “Clean” button. Press this button once to send your Roomba back to its Home Base.

How do I get my Roomba back to the dock?

How to Send Roomba Home to Dock

  1. Verify that the home base is plugged in. If it’s not, your Roomba will be unable to locate it to dock. …
  2. Pick the Roomba up and set it down within five feet of the home base.
  3. Press the “Spot” and “Clean” buttons simultaneously. The Roomba will now drive into the home base to dock.
THIS IS INTERESTING:  How do I run the robot framework test in Pycharm?

How does Roomba find home base?

When you press the dock command on Roomba, the home base/charging dock emits infra red signals which are detected by the infrared receiver on its front bumper. It then follows the signal and docks into its home base automatically.

Where is the best place to put my Roomba dock?

Positioning guideline:

  • At least >1.5 ft (0.5 m>) on each side of the Home Base®.
  • At least >4 ft (1.2 m>) in front of the Home Base®, with no furniture such as tables or chairs within this area.
  • At least >4 ft (1.2 m>) between the Home Base® and any stairs.
  • At least >8 ft (2.4 m>) from Virtual Wall® barriers.

How does Roomba know to dock?

When the battery power is running low, the robot uses its infrared sensors to locate the charging dock, which also emits infrared beams. The Roomba then follows the beams’ path toward the dock where it can recharge before resuming the cleaning session.

Can I move my Roomba home base?

You can move a Roomba base. Your Roomba base location is mapped into the robot to ensure it finds its way back and recharges itself to continue cleaning or retire after cleaning, but nothing says your Roomba can’t find its way back to this base even after it has been moved.

How do I reset a Roomba for a new house?

Press and hold HOME and SPOT Clean buttons on your robot for 10 seconds. When the button is released, Roomba will play the reboot tone. Wi-Fi connected Roomba 800 series. The reboot procedure is the same for Roomba 500 & 600 series, and also Wi-Fi connected Roomba 600 & 800 series.

THIS IS INTERESTING:  How do you reboot iRobot?

Why wont my Roomba leave the dock?

Re: Roomba won’t leave the dock

There may be mechanical interference preventing the Roomba from leaving the base. Check the charging contacts on both the underside of the Roomba and the top of the homebase.

How long does it take for Roomba to dock?

Check the area around the charging base. Depending on the size of the room you Roomba should run for sometime between about 40 minutes and an hour.

Why does Roomba take so long to dock?

Make sure that the docking station IR windows are clean and not full of dust, finger prints smudges. Try to move the doc station into another area of the house and try to doc it again. Make sure it’s within 5 feet without any objects that could interrupt it’s straight path to the doc station.